STOPS & CLAMPS

‘PARSELL’ & ‘MINNI-DIE’ : Manufacturers of ‘Minni-Die’ C-Frame unitised hole punching, notching & cropping tools

for sheet metals, roll formed sections, aluminium extrusions, tubes & plastics

40 Trent South Industrial Park, Little Tennis Street, Nottingham.

Nottinghamshire. ENGLAND. NG2 4EQ.   U.K.

  Tel Int +44 (0)115 941 9009  Fax Int +44(0)115 950 3921 Mobile: +44(0)7860 351 648

Used in Press Brakes, Mechanical Presses, Hydraulic Presses & Custom built hole punching machines

Parsell logo

12/11/2008 08:00am

Parsell logo

Best viewed at 800 x 600 in explorer 5 / 6

Examples of typical Stops, Indexers and End Stops

Special End Stops

Special stops with base tenons

above: This is an example of an end stop fitted with a base tenon to slide/adjust in a rebate in the bed plate. Location of the stop can be by a clamping bolt or a stab pin to locate in pre drilled dowel holes in the bed.

Standard Stop Pin Units

Standard cast stops for use on a press

above: Standard stop pin units are available where the location pin has a concentric base dowel or the cast body has a concentric dowel hole to suit a standard dowel location. From left to right the illustrations shows Model 700P, 800P and 1800P. These all suit the ‘Minni-Die’ die height of 65,0mm but others are available to suit different die heights and applications.

Purpose Made Back stops

Special back stops and spare mushroom pins

above: These stops are typical examples of purpose made back or side stop blocks that can accept standard dowel pins or ‘mushroom’ pins to quickly vary the back stop dimension settings.

Flip Over End Stops

Flip over special stop with inlaid rule

above: This is a purpose made flip over end stop which would be used for repeat indexing. The stop would be set to suit the first blow of the strip or section material, then lifted out of the way to allow the strip or section to be fed to a length stop some distance away.

 

Material Indexing Stops

Flip up stop for material indexing

above: When punching roll formed sections, strip and extrusions either with a single tool or a tool set up that needs repeat blows, an indexing stop is required for locations of susequent blows. The set up here has one tool and a number of blows to complete the punching in the component. This could be a product like sliding door track with fixing holes punched at centres.

below: standard sheet support arms to suit 65,0mm die height

Diagram of angle iron support arms

 

 punching: notching: cropping: stops: bed: strikers: templates: bend knives: vee dies: applications: hydraulic: tube: what’s new: contact us:

rounds / 10dia / 14dia / 20dia / 30dia / 8dia / 41dia / 51dia / 71dia / 91dia / 127dia / shapes / finger dies / high dies / plate /

models M10 / M14 / M20 / M30 / M8 / M41 / M51 / M71 / M91 / M127 / M14PF / M20PF / M30PF / SM14 / SM20 / SM30 / M1055 / M27 / M50N / M100N

please contact webmaster with any comments or problems with this site. Copyright 2007 Parsell Minni-Die & G M Parsell. All rights reserved

Registered Office: Roter Adler, Thoroton. Nottinghamshire. NG13 9DS.UK : Parsell Ltd : Company registered No: 0343 4947